Passivation of stainless steel pickling and electroanalysis the difference of polishing

The outside processing technology of stainless steel has a lot of, for example: Cleanness removes oil, divide rust, passivation, pickling, antirust, polishing, eletroplate, electrophoresis is waited a moment, manufacturer of products of each stainless steel can produce according to his technical demand chooses different appearance to handle way. In last few years, the contrast that apply is adept with extensive technology passivation of stainless steel pickling and stainless steel electroanalysis the outside processing technology such as polishing. But, is there are a lot of brothers still pickling of very clear stainless steel passivation and electroanalysis where is the difference of polishing? Borrow this, we are done with brief introducing, so that we know,mix understanding.

1, passivation of stainless steel pickling: Since general stainless steel is whole immerse in fluid of passivation of stainless steel pickling, till stainless steel appearance appears thoroughly after even and collective silvery white, reassume gives workpiece to erode with clear water clean appearance can. Great majority has the manufacturer of stainless steel products that pickling passivation requests, because want to raise skin of oxidation of the solder scar that eliminates appearance, high temperature,be, make stainless steel outside colour is consistent and beautiful. The suitable scope of this technology is comparative and wide: For example: Conduit of stainless steel chemical industry is handled, pickling of stainless steel weldment is handled, cleanness of stainless steel valve is handled... . Because fluid of passivation of stainless steel pickling is to be able to repeat a loop to apply, not rising, do not evaporate, without Huang Yan and hydrogen clear picture happens, reason operation environment is good, also not the device with special demand, love because of what suffer manufacturer of products of capacious stainless steel fully.

2, stainless steel electroanalysises polishing: The stainless steel that is a demand polish secures the hanger in major to go up, will electroanalysis next polishing equipment is opened, voltage of power source of a mix up, the stainless steel that already will secure again immerge electrify and add lukewarm in the electrolyte to 75 degrees, general hour is 1-3 minute, to outside light rear and desirable give work, erode clean. The bright luminosity that its express is can request a standard differently according to each manufacturer, can be adjusted artificially and hold accuse. Electroanalysis the appearance of stainless steel workpiece after polishing is handled all appears affirmative and collective light, exquisite action, its appearance glossiness can arrive at effect of 8K lens side. And if abiding light is new, do not fall off absolutely. This technology holds the post of the stainless steel goods of meaning exterior applicably, general the polish of stainless steel appearance of all 200 series, 300 series, 400 series, produce efficiency is tall, cost is low, without odour developing bazoo, operation environment is good, be those who replace traditional machinery and craft polish is best choose.

Through the brief introduction of above, believe we are right passivation of stainless steel pickling and electroanalysis the difference of polishing had sure knowledge. The stainless steel appearance that originally these two kinds of technologies handle is very beautiful.

The article arranges storage-rack.onsonhardware.com of processing factory of drill rod solder