Solder equipment safeguards the note with time conserve

One, the conserve to welding torch

1. is time to electric mouth undertake examining, replace
Because wear away,the aperture of electric mouth greatens, can bring about electric arc to be not stabilized, welding line exterior worsens or stick silk (flash back) ; Electric mouth ending is stuck on splatter, meeting sending silk becomes not smooth; Electric mouth is twisted incompactly, whorl joins place will be calorific and solder is dead.

2. is time to spring tube undertake arrange and be replacinged
After spring tube is used for a long time, will stockpile the plating bits of pink of a lot of iron, dust, welding wire, can make send silk to be not stabilized so. Time so arrange very main, can be in its zigzag stealthily knock, make stockpile content is shaken off, use next compress air to blow off. The oily dirty that goes up to tube should use a brush to be in oil rinse, use next compress air aspiration. If spring tube is wrong silk or austere be out of shape labyrinthian, be about to replace new tube. When changing a canal, should affirming is appropriate the welding wire diameter that uses at place and length, and cutting section do not present burr.

3. is examined to what insulating envelope encircles
If get off,insulation ferrule applies solder, splatter to be in conglutinate nozzle inside make nozzle and live part guide. Welding torch perhaps because of short circuit burn down. Pour out of equably to make safeguard gas at the same time, must mount insulation ferrule.

2, to sending silk the conserve of equipment

1. force is adjusted
The welding wire diameter that force of round screw die sending silk should use according to place adjusts appropriately. If pressure is insufficient, welding wire will skid; Pressure is too great, welding wire will be engraved, be out of shape. If use medical core welding wire, send filar annulus force to want to compare solid core welding wire small.

Of straight equipment of correct of 2. welding wire adjust
Of straight equipment of welding wire correct adjust method to press machine those who plant is different and different, want what the basis makes manufacturer to indicate the appropriate position that adjusts diameter of corresponding welding wire.

3. welding wire dish device
If device does not reach the designated position, welding wire dish there is the risk that fall down in rotate, produce austere consequence. Should examining piece of apply the brake or bolt well is reliable ground mount.

The article arranges storage-rack.onsonhardware.com of processing factory of drill rod solder